AF 14 Quick Coupler Locking KO Rod System This knockout rod assembly is recommended for ejector plate flush with the back of the ear plat se with MUD standard mold base adapter frame The center rod locks the ejector plate to the systems. It permits the molding machines special knockout rod installed on the machine's hydraulic knockout system to operate at its hydraulic knockout plates. Two rods, threaded maximum stroke. The KO system is designed for adjusting to proper length, are also installed ith three push points and one pull back. The on the machine s knockout plate flush with the A& Brods, supplied extra long for finishing to inside surface of the adapter frames rear precise length, are threaded into the molds clamp plate Knockout Rod Assembly and Rods ITEMNO.DESCRIPTION K.O. Assy. PLKA 15 Knockout rod assembly (1 required) FA-X MLKS 193 Mold knockout locking rod (1 required PKR 194 Push rods(2 required Rest buttons MKS 195 Knockout spacer rod(2 required Bottom Clamp Plate Locking Rod Mold Base K0 Spacer Rod 8100 ⑩N Mold Base K.O. Push Rod For each press supply THD, P&l Press ejector plate ess p (3 Adapter frame clamp pla 4 Adapter ear plate MASTER U.s.800-626-6653awww.dme.net UNIT DE Canada8o0-387-6600 m Europe32-15-215011Quick Coupler Locking KO Rod System AF 14 U.S. 800-626-6653 ■ www.dme.net Canada 800-387-6600 ■ Europe 32-15-215011 This knockout rod assembly is recommended for use with MUD standard mold base adapter frame systems. It permits the molding machine’s hydraulic knockout system to operate at its maximum stroke. The KO system is designed with three push points and one pull back. The A & B rods, supplied extra long for finishing to precise length, are threaded into the mold’s ejector plate flush with the back of the ear plate. The center rod locks the ejector plate to the special knockout rod installed on the machine’s hydraulic knockout plates. Two rods, threaded for adjusting to proper length, are also installed on the machine’s knockout plate flush with the inside surface of the adapter frame’s rear clamp plate. B – X Mold Base K.O. Spacer Rod Mold Base K.O. Push Rod A – X Mold Base K.O. Locking Rod Quick Coupler K.O. Assy. Rest Buttons X Bottom Clamp Plate Ear Plate Adapter Assy Ø 1.00 Rest Buttons THD 1 2 3 4 For each press supply: THD, P & L 1 Press ejector plate 2 Press platen 3 Adapter frame clamp plate 4 Adapter ear plate Quick Coupler Locking Knockout Rod Assembly and Rods ITEM NO. DESCRIPTION PLKA 192 Knockout rod assembly (1 required) MLKS 193 Mold knockout locking rod (1 required) PKR 194 Push rods (2 required) MKS 195 Knockout spacer rod (2 required) MUD_adapter_rev1 11/3/05 3:15 PM Page 14