CFX制 Curvature sensitive mesh Surface mesh parameters Value(degrees)-code chooses edge Action: Mesh Param length such that the set angle is subtended at the centre of circle with radius equal to set defaults spacing smallest radius of curvature default is 18 「o406356 degrees(recommended 5 to 60 degrees) Surface mesh spacing Value(fraction )-deviation of mesh from Angular resolution T surface as a fraction of local minimum radius of curvature 厂ooo0406356 aximum Edge Length Minimum edge length-lower bound on Expansion Factor length scale(default 1% of volume 「12 background scale) Adjust meshing spacings Maximum edge length-upper limit on length scale(default same as volume 厂 Apply Stretch background scale) Volume expansion factor-rate of Proximity Edge expansion of mesh scale from surface to 厂 Surface Interior 710 CFX5.5V5.5.1H 2001AEA TechnologyCFX 5.5 V 5.5.1H © 2001AEA Technology 7-10 Surface mesh parameters - Value (degrees) - code chooses edge length such that the set angle is subtended at the centre of circle with radius equal to smallest radius of curvature. Default is 18 degrees (recommended 5 to 60 degrees) - Value (fraction) - deviation of mesh from surface as a fraction of local minimum radius of curvature - Minimum edge length - lower bound on length scale (default 1% of volume background scale) - Maximum edge length - upper limit on length scale (default same as volume background scale) - Volume expansion factor - rate of expansion of mesh scale from surface to interior Curvature Sensitive Mesh