Massachusetts Institute of Technology Department of Electrical Engineering and Computer Science 6.111-Introdi igital Systems Labo Report guide Introduction The purpose of this memorandum is to describe general requirements for the reports you
assachusetts Institute of Technology Department of Electrical Engineering and Computer Science 6. 111-Introductory Digital Systems Laboratory Project resources Project resources are allocated on a per student basis. This means that a two-person
Introduction (chapter objectives) Bit error rate for binary systems (unipolar, polar, bipolar, ooK, BPsK, FsK, and MSK Output signal-to-noise ratio for analog systemS(AM, SSB, PM, and Fm)
5. Introduction (Chapter objectives) Amplitude modulation and single sideband Frequency and phase modulation Digitally modulated signals(OoK, BPSK, FSK, MSK MPSK, QAM, QPSK, a/4QPSK, and OFDM) Spread sprectrum and CDMa system
Introduction (chapter objectives) Complex envelopes and modulated signals Spectra of bandpass signals Nonlinear distortion · Communication circuits(mixers, phase- locked loops, frequency synthesizers, and detectors) Transmitters and receivers · Software radios
3.9 Time-Division Multiplexing Definition. Time-division multiplexing (TDM) is the time interleaving of samples from several sources so that the information from these sources can be transmitted serially over a single communication channel
Chapter Objectives Analog-to-digital signaling(PCM and delta modulation) Binary and multilevel digitals signals Spectra and bandwidths of digital signals Prevention of intersymbol interference Time division multiplexing Packet transmission
