Often in multiple-effect evaporators the concentration of the liquid being evaporated changes drastically from effect to effect, especially in the latter effects. In such cases, this phenomenon can be used to advantage by staging one or more of the latter effects. Staging is the operation of an effect by maintaining

Common, everyday water is a major consideration in a pharmaceu￾tical plant. The final product or any of its intermediate materials can only be as contaminant-free as the water available at that stage. Water may be an ingredient or used principally to wash and rinse product contact components and equipment. Water is also used to humidiethe air, to generate clean steam for sterilization, to cool or heat, as a solvent, for drinking and sanitary uses, etc. To better control this critical media

Crystallization is one of the oldest methods known for recovering pure solids from a solution. The Chinese, for example, were using crystallization to recover common salt from water some 5000 years ago. The perfection and beauty of the crystal which fascinated the early tribes now leads to a product of high purity and attractive appearance

“Evaporation is the removal of solvent as a vapor from a solution or slurry. The vapor may or may not be recovered, depending on its value. The end product may be a solid, but the transfer of heat in the evaporator must be to a solution or a suspension of the solid in liquid if the apparatus is not to be classed as a dryer. Evaporators are similar to stills or re-boilers of distillation

Fluid mixing is essential in fermentation processes. Usually the most critical steps in which mixers are used are in the aerobic fermentation process. However, mixers are also used in many auxiliary places in the fermentation process and there are places also for agitation in anaerobic fermentation steps

Cross-flow filtration (CFF) also known as tangential flow filtration is not of recent origin. It began with the development of reverse osmosis (RO) more than three decades ago. Industrial RO processes include desalting of sea water and brackish water, and recovery and purification of some fermentation products. The cross-flow membrane filtration technique was next applied to the concentration and fractionation ofmacromolecules commonly recognized

The theoretical concepts underlying filtration can be applied towards practical solutions in the field. Comprehension of the basic principles is necessary to select the proper equipment for an application. Theory alone, however, can never be the basis for selection of a filter. Filtration belongs to the physical sciences, and thus conclusions must be based on experimental assay. It is, however, helpful in understanding why a slurry is more suitable for one design of filtration equipment than another

The introduction of fluidfoil impellers, as shown in Fig. 9a through 9f, give a wide variety of mixing conditions suitable for high flow and low fluid shear rates. Fluidfoil impellers use the principles developed in airfoil work in wind tunnels for aircraft. Figure 10a shows what is desirable, which is no form separation of the fluid, and maximum lift and drag coefficients, which is what one is trying to achieve with the fluidfoil impellers. Figure 10b shows

A common problem for a biochemical engineer is to be handed a microorganism and be told he has six months to design a plant to produce the new fermentation product. Although this seems to be a formidable task, with the proper approach this task can be reduced to a manageable level. There are many ways to approach the problem of optimization and design of a fermentation process

Fermentation and Biochemical Engineering Handbook microorganisms, mammalian cells, plant cells, and tissue. It is our sincere hope that the reader will find this chapter helpful in determining the best conditions for cultivation and the collection of scale-up data. Hopehlly, this knowledge will, in turn, facilitate the transformation of worthwhle research