O接口的作用功能定义 计算机/单片机与外设之间起桥梁作用的 电路或部件接口(interface) 协调两者间的差异

第一、二章要点: 前提:定量分析建立在“电路模型”基础上本课程主要讨论“线性非时变”电路一参考方向,关联参考方向注意:v,i不关联时p=-ui

I Consider the graph shown in Fig. 15-15. Denote the tree made up of b 6, bs, and b, by t (a)Find all the fundamental loops of this graph corresponding to T (b) Find all the fundamental cutsets of this graph corresponding to t (c) Write the incidence matrix of this graph choose n 4 as the datum

A cosine voltage is zero and increasing at t=-1 6ms; the next zero crossing occurs at t 4.65ms. (a)Calculate T, f, and @.(b) If v(0)=20V, find v(t).(c)By what angle does v(t) I(t)=5cos(t-110°)A? 2 For the sinusoidal waveform shown in

We consider each term of the Fourier aeries representing the voltage as a single source. The equivalent impedance of the network at no is used to compute the current at that harmonic. XL(n) =noL and XC() =-1/noC The sum of these individual responses is the total response i

1. Establish a normal tree. tree branches--Us, C(, R) cot ree(chords)-i,,(, R) 2. Assign voltage and current variables. Assign a voltage (with polarity reference) to every capacitor and a current(with arrow) to every inductor; there are the state variables. Indicate the voltage across every tree branch and the current through every link in terms of the source voltages, source currents,and the state

14-1状态、状态变量及状态方程 一、状态 在某给定时刻,电路所必须具备的最少量的信息。 二、状态变量 如电容电压uc,电感电流i 三、状态方程 状态方程:以状态变量为未知量而建立的一阶微分方程组

特勒根定理电路理论中对集总电路普遍适用的 基本定理,与基尔霍夫定律等价,它有两种 形式。 特勒根定理1:对于一个具有n个结点和b条支路 的电路,假设各支路电流和支路电压取关联 参考方向,并令i、u分别为b条支路的电流 和电压。则对任何时间t,有:

一、例题精解 【例题6.1】图6.1(a)所示电路中,已知R=R1=R2=R3=22,C=1F,L=1H,E=12V。电路原来处于稳定状态,t=0时闭合开关S.试求初始值i(0+)ic(0+)、u(0+)

1.简述图1所示的降压斩波电路的工作原理。 2.在图1所示的降压斩波电路中,已知E=200V,R=10,L值极大,E=30V。采用脉宽调制控制方式,当T=50us,ton=20us时,计算输出电压平均值U、输出电流平均值I