Behavior Modeling Only the functionality of the circuit, no structure No specific hardware intent For the purpose of synthesis, as well as simulation IN1，…，INn IF in1 THEN OUT1，…，OUTn FOR j IN high DOWNTO low LOOP

Copyright 8 1997 by Noyes Publications No part of this book may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying, recording or by any information storage and retrieval system, without permission in writing from the Publisher. Library of Congress Catalog Card Number: 96-29055 Printed in the United States

The drying operation is often the final step of a manufacturing process. Indirect drying will be discussed in this section; it is the process of removing liquid by conductive heat transfer. Sometimes drymg is apart ofthe manufacturing process itself, as in the case of seasoning oftimber or in paper making, but generally, the reasons for carrying out a drying operation are:

Often in multiple-effect evaporators the concentration of the liquid being evaporated changes drastically from effect to effect, especially in the latter effects. In such cases, this phenomenon can be used to advantage by staging one or more of the latter effects. Staging is the operation of an effect by maintaining

The engineer designing an ion exchange column operation usually will prefer to work with the simplest kinetic model and linear driving force approximations. The weakness ofthis approach is that any driving force law only regards the momentary exchange rate as a hnction of the solute concentration in the bulk solution and the average concentration in the particle, neglecting the effect of concentration profiles in the particle

Liquid-liquid extraction is a unit operation frequently employed in the pharmaceutical industry, as in many others, for recovery and purification of a desired ingredient from the solution in which it was prepared. Extraction may also be used to remove impurities from a feed stream

The introduction of fluidfoil impellers, as shown in Fig. 9a through 9f, give a wide variety of mixing conditions suitable for high flow and low fluid shear rates. Fluidfoil impellers use the principles developed in airfoil work in wind tunnels for aircraft. Figure 10a shows what is desirable, which is no form separation of the fluid, and maximum lift and drag coefficients, which is what one is trying to achieve with the fluidfoil impellers. Figure 10b shows

Phosphorus in plant physiology P content of plants Approximately 0.2% of plant dry weight is P Plants require a relatively large amount of P. The phosphate concentration in the cytosol is maintained at fairly constant concentrations in the 5 to 8 mol/m3 regardless of the external phosphate concentration except under severe P deficiency. By contrast is the vacuolar phosphate concentration

Specific nutritional requirements of microorganisms used in industrial fermentation processes are as complex and varied as the microorganisms in question. Not only are the types of microorganisms diverse (bacteria, molds and yeast, normally), but the species and strains become very specific as to their requirements

3.0 BIOREACTORS FOR PLANT CELL TISSUE AND ORGAN CULTURES fly Shinsaku Takayama) 3.1 Background of the Technique-Historical Overview HaberlandtL'] first reported plant cell, tissue, and organ cultures in 1902. He separated plant tissues and attempted to grow them in a simple nutrient medium. He was able to maintain these cells in a culture medium for