5.0 Introduction 5.1 Device Structure and Physical Operation 5.2 Current-Voltage Characteristics 5.3 The BJT as an Amplifier and as a Switch 5.4 BJT Circuits at DC 5.5 Biasing in BJT Amplifier Circuits 5.6 Small-Signal Operation and Models 5.7 Single-Stage BJT Amplifiers 5.8 The BJT Internal Capacitances and High-Frequency Model 5.9 Frequency Response of the Common-Emitter Amplifier 5.10 The Basic BJT Digital Logic Inverter 5.11 The SPICE BJT Model and Simulation Examples

4.0 Introduction 4.1 Device Structure and Physical Operation 4.2 Current-Voltage Characteristics 4.3 MOSFET Circuits at DC 4.4 The MOSFET as an Amplifier and as a Switch 4.5 Biasing in MOS Amplifier Circuits 4.6 Small-Signal Operation and Models 4.7 Single-Stage MOS Amplifiers 4.8 The MOSFET Internal Capacitances and High-Frequency Model 4.9 Frequency Response of the CS Amplifier 4.10 The CMOS Digital Logic Inverter 4.11 The Depletion-Type MOSFET 4.12 The SPICE MOSFET Model and Simulation Example

《供应链系统设计与管理》课程授课教案（讲义）Chapter 02（Lecture 3）Single Stage Inventory Control

2.1 Introduction 2.2 Single Stage Inventory Control 2.2.1. Economic Lot Size Model 2.2.2. the Effect of Demand 2.2.3. Single Period Models 2.2.5 Multiple Order Opportunities 2.2.4. What If the Manufacturer Has an

长江大学：《沉积岩石学》课程教学课件（讲稿）第二章 沉积岩的形成及演化 第四节 沉积后作用及其阶段划分 Postsedimentation process and stage division

西安交通大学：多期风险度量与多阶段投资组合选择问题（博士学位论文）Multi-period Risk Measures and Multi-stage Portfolio Selection Problems

复旦大学：微电子工程教学资源（参考论文）A Wideband CMOS Variable Gain Low Noise Amplifier Based on Single-to-Differential Stage for TV Tuner Applications

Comparing the Effects of Aromatherapy With Rose Oils and Warm Foot Bath on Anxiety in the First Stage of Labor in Nulliparous Women

Being aimed to developing intermetallic base structural materials to be worked at above 1000℃, a systematic investigation has been performed of the fundamental crystallographic structure, phase constitution map, density-composition dependence, oxidation resistance and general mechanical behaviour for the ternary intermetallic alloys in the Nb-Ti-Al system. Promissing results have been obtained at the initial stage in the current program. The 1100℃ high temperature strength at the strain rate of 10-2/s and 10-5/s for the ternary compound NbTiAl3 （γ1） base alloys are generally much higher than that of the binary compound TiAl （γ）, especially in the γ1 + α2 phase region, it is as high as twice as that of TiAl. The densities are 4.1-4.79g/cm3, depending on relative amount of the intermetallics involved and the density difference between the intermetallics. The oxidation resistance at th

针对锂离子电池荷电状态（Stage of charge，SOC）在线估计精度不高，等效电路模型法估计精度与模型复杂度相矛盾的问题，本文对扩展卡尔曼滤波算法进行了改进，并以电池工作电压、电流为输入，对应等效电路模型法的SOC估计误差为输出，采用极限学习机算法，建立基于输入输出数据的SOC估计误差预测模型，采用物理–数据融合方法，基于误差预测模型，建立了等效电路模型法结合极限学习机的锂离子电池SOC在线估计模型。仿真结果表明，改进扩展卡尔曼滤波算法提高了算法的估计精度，而物理–数据融合的锂离子电池SOC在线估计模型减小了由电压、电流测量所引入的估计误差，克服了等效电路模型法估计精度与模型复杂度之间相矛盾的问题，进一步提高了SOC的估计精度，满足估计误差不超过5%的应用需求