• 弯曲内力 – 弯曲的概念和实例 – 受弯杆件的简化 – 剪力和弯矩 – 剪力方程和弯矩方程 剪力图和弯矩图 – 载荷集度、剪力和弯矩间的关系 – 平面曲杆的弯曲内力 • 弯曲应力 – 纯弯曲 – 纯弯曲时的正应力 – 横力弯曲时的正应力 – 弯曲切应力 – 提高弯曲强度的措施

• 应力状态概述 • 二向和三向应力状态的实例 • 二向应力状态分析-解析法 • 二向应力状态分析-图解法 • 三向应力状态 • 广义胡克定律

• 组合变形和叠加原理 • 拉伸或压缩与弯曲的组合 • 斜弯曲 • 扭转与弯曲的组合

• 压杆稳定的概念 • 两端铰支细长压杆的临界压力 • 其他支座条件下细长压杆的临界压力 • 欧拉公式的适用范围 经验公式 • 压杆的稳定校核 • 提高压杆稳定性的措施

深圳大学：《塑料成型工艺与模具》课程教学资源（教材讲义）Chapter 3 Plastics, Mold Materials

四川外语学院：《科技翻译》课程教学资源_week 4_Nuclear Materials-1

基于密度泛函理论的第一性原理,采用Materials Studio 6.1软件的CASTEP模块对方解石的晶体结构及与水分子及水分子簇的吸附作用进行了研究.结果表明,方解石在参与化学反应时O的活性最强,C和Ca次之;其次确定了最稳定解离面为{101

Being aimed to developing intermetallic base structural materials to be worked at above 1000℃, a systematic investigation has been performed of the fundamental crystallographic structure, phase constitution map, density-composition dependence, oxidation resistance and general mechanical behaviour for the ternary intermetallic alloys in the Nb-Ti-Al system. Promissing results have been obtained at the initial stage in the current program. The 1100℃ high temperature strength at the strain rate of 10-2/s and 10-5/s for the ternary compound NbTiAl3 （γ1） base alloys are generally much higher than that of the binary compound TiAl （γ）, especially in the γ1 + α2 phase region, it is as high as twice as that of TiAl. The densities are 4.1-4.79g/cm3, depending on relative amount of the intermetallics involved and the density difference between the intermetallics. The oxidation resistance at th

The effects of different firing temperatures on the stability of perovskite phase, grain size, and dielectric properties were investigated by XRD, TEM, SEM and dielectric measurements. The dielectric ceramics of Pb(Mg1/3Nb2/3)O3-PbTiO3-BaTiO3 system were obtained by chemical coprecipitation in water. The ceramics have higher dielectric constant (7003-9714), lower firing temperature (950-1150℃), quite uniform microstructure with grain size less than 2.5μm, and lower temperature coefficients of capacitance. As a result, it was confirmed that the simple and low cost chemical route used namely coprecipitation in water is a desired meth-od for preparing high property dielectric materials applicable to multilayer capacitors

Modern Civilization Biological Technology Information Technology Materials Science and Engineering