使用本电子版讲义请注意以下事项: 1.本讲义只起辅助教学作用 2.课程内容以课上讲授内容为准. 3.为适应本课程教学的需要,本讲义将不断更

(1)只对对定常线性系统有意义; (2)系统初始值(状态)为零; (3)既可对系统求取,也可对元件求取 (4)不同的系统传递函数可以相同

1.本讲义只起辅助教学作用 2.课程内容以课上讲授内容为准. 3.为适应本课程教学的需要,本讲义将不断更新.其最新版本可在ftp://ctgt,hi.edu.cn处下

(1)极点完全决定系统的稳定性; (2)极点在很大程度上决定系统的动态性能;即:极点决定系统响应的类型;极点与零点一起决定系统响应的幅值;

8.1离散系统的基本概念 8.2信号的来样与保持 8.3Z变换与Z反变换 8.4离散系统的数学模型 8.5稳定性与稳态误差 8.6离散系统的动态性能分析

Frequency response is the analysis of the response of systemswhen subjected to a sinusoidal change in input. When a linear system is subjected to a sinusoidal input, its ultimate response is also a sustained sinusoidal wave, with the same frequency. The figure below compares the output response of a system (solid line) with a sinusoidal input (dashed line) disturbing the system

3.1 Introduction 3.2 Typical test signals for time response of control systems 3.3 First –Order Systems 3.4 Performance of a Second-Order System 3.5 Concept of Stability 3.6 The Relative Stability of Feedback Control Systems

1 Introduction 2 Deterministic Dynamic Programming and Viscosity Solutions 2.1 Introduction 2.2 Value Functions are Viscosity Solutions 2.3 Comparison and Uniqueness 3 Stochastic Control 3.1 Some Probability Theory 3.2 Controlled State Space Models 3.3 Filtering 3.4 Dynamic Programming - Case I : Complete State Information 3.5 Dynamic Programming - Case II : Partial State Information 3.6 Two Continuous Time Problems 4 Robust Control 4.1 Introduction and Background 4.2 The Standard Problem of H∞ Control 4.3 The Solution for Linear Systems 4.4 Risk-Sensitive Stochastic Control and Robustness 5 Optimal Feedback Control of Quantum Systems 5.1 Preliminaries 5.2 The Feedback Control Problem 5.3 Conditional Dynamics 5.4 Optimal Control 5.5 Appendix: Formulas for the Two-State System with Feedback Example 6 Optimal Risk-Sensitive Feedback Control of Quantum Systems 6.1 System Model

3.6.1 稳态误差的定义 3.6.2 系统类型 3.6.3 扰动作用下的稳态误差

System compensation is the process of designing a controller that will produce an acceptable transient response while maintaining a desired steady-state accuracy .These two design objectives are conflicting in most systems ,since small errors imply high gains reduce system stability and may even drive the system unstable .Compensation may be thought of as the process of increasing the stability of a system without reducing its accuracy below minimum acceptable standards